The number one site for CADmep™ ESTmep™ and CAMduct™ users... | |
including additional topics and discussions covering AutoCAD®, Navisworks®, Revit®, GTP Stratus, and much more |
|
Started in 2003, XtraCAD.com was set up as a platform to aid users of the newly evolving range of 3D parametric modelling software utilities being developed by Micro Application Packages (MAP) from Blackpool, England. Throughout the continual development of these applications, including the acquisition of MAP by Autodesk® in 2011 and subsequent rebranding, we have remained the first port of call for many users of all levels seeking assistance. We are proud that Autodesk 'fully understand the importance of XtraCAD for the CADmep and Fabrication community' and acknowledge that we 'do a great service by maintaining this community and understand it is important for users'. Join us now and become a part of the future of Building Services Coordination & BIM. |
|
EU Law: By signing in to this site I agree that XtraCAD.com may set cookies on my browser.
Today at 16:57:39 by Tye Austin | Views: 49 | Comments: 4
I am always needing to exclude fittings on the DWV copper tab in a waste service or vent service because if I use the Trim command to complete an offset or sometimes with the Multipoint Fill command, ... Oct 30, 2024, 15:45:11 PM by VirtualPilot | Views: 214 | Comments: 5
Can anyone confirm my suspicion that even though you can create price lists for different materials, it is actually NOT implemented? I can create different prices for different materials bu... Oct 29, 2024, 18:09:07 PM by sheetmetalman | Views: 215 | Comments: 8
Anyone using CID#2900. It works when I remove the material. I have all the sizes in the Spec for the material, and it wont work with any material. If I remove the material it red... Oct 28, 2024, 21:21:23 PM by sephirothnk | Views: 132 | Comments: 0
I think there should be a Label Arrow that you can configure to point directionally and that no matter which direction you or the Part on the table are facing you know which way to orient the label as... Oct 28, 2024, 21:06:32 PM by sephirothnk | Views: 140 | Comments: 1
We should have the ability to change the part material of any piece regardless of whether another piece is connected on both ends or not Pages: [1]
|
Re: MEP Fabrication Parts Tabs and Priority with fill by Tye Austin
[Today at 18:54:10] Re: MEP Fabrication Parts Tabs and Priority with fill by rjdonahue [Today at 18:45:13] Re: MEP Fabrication Parts Tabs and Priority with fill by Tye Austin [Today at 17:37:06] Re: MEP Fabrication Parts Tabs and Priority with fill by madcad [Today at 17:21:36] MEP Fabrication Parts Tabs and Priority with fill by Tye Austin [Today at 16:57:39]
From here you may access additional areas of the site..
|