« previous next »
Pages: [1]   Go Down

Author Topic: Burning one piece of a fitting  (Read 1655 times)

0 Members and 1 Guest are viewing this topic.

Offline AKTopic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
Burning one piece of a fitting
« on: May 16, 2012, 20:52:31 PM »
If you need to re-burn 1 piece of a fitting how do you do it?  We are using a vulcan table non touch screen version.
Logged

Offline Bonedigger

  • Premier Member
  • *****
  • Posts: 527
  • Country: us
  • Gender: Male
    • Hercules Industries
Re: Burning one piece of a fitting
« Reply #1 on: May 16, 2012, 21:31:40 PM »
For the non touch screen, you either have to dry run the sheet up to the point where that piece is and then burn, or just renest the piece onto a different sheet. I usually just renest the piece.
Logged
Chris
Autodesk Fabrication CAMduct 2019 v3.07.545 (2019.1.0), Autodesk Fabrication ESTmep 2022 v22.0.110.2 (2022.0.0.F) Windows 10, 64-Bit
Pages: [1]   Go Up
« previous next »