« previous next »
Pages: [1]   Go Down

Author Topic: Shade isometric view on label  (Read 1883 times)

0 Members and 1 Guest are viewing this topic.

Offline AKTopic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
Shade isometric view on label
« on: May 16, 2012, 21:03:50 PM »
Can you shade the side of the fitting you are working on the isometric picture on the label like this.
Logged

Offline Bonedigger

  • Premier Member
  • *****
  • Posts: 527
  • Country: us
  • Gender: Male
    • Hercules Industries
Re: Shade isometric view on label
« Reply #1 on: May 16, 2012, 21:35:37 PM »
No. That's something that's actually coded into the vulcan label itself that you're illustrating.
Logged
Chris
Autodesk Fabrication CAMduct 2019 v3.07.545 (2019.1.0), Autodesk Fabrication ESTmep 2022 v22.0.110.2 (2022.0.0.F) Windows 10, 64-Bit

Offline AKTopic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
Re: Shade isometric view on label
« Reply #2 on: May 17, 2012, 13:23:16 PM »
Well maybe that would be something to add to the wish list I guess.  

At least I was able to get the cam label layout to match the quickpen ones making it less confusing to the shop guys in the switch to using tsi.
Logged

Offline tnbquilt

  • Premier Member
  • *****
  • Posts: 726
  • Country: us
  • Gender: Female
Re: Shade isometric view on label
« Reply #3 on: Jun 08, 2012, 20:17:20 PM »
My shop guys were real confused when we swapped over. That part about breaking the fitting was the worst part, because this software uses different terminology than Vulcan. We had everything brok backwards for a week or more until I found something in the help section about how to read the label.
Logged
Tammy Beaman BHW Sheet Metal Co.
Architecture 2011 - CADduct version 2.41.037
Pages: [1]   Go Up
« previous next »