Fabrication CADmep™ > CADmep™ Users

jobinfo is blank after saveas

(1/1)

bknapton:
Has anyone run accross this?  As soon as a saveas is done on a DWG the jobinfo is blank.  Prior to saveas the jobinfo was filled out for current job.  Curious if this is a glitch or standard process.

dopefish:
Bumping this. I have a user running into this same problem. Anyone got any ideas?

VirtualPilot:
I have noticed that information is NOT saved if no ITEMS are on the job, I can open a new drawing, fill all information, save and come back later and all is blank again, now I got in the custom of adding a piece of duct then fill the information...

dopefish:
Good to know. This user has items drawn. But i wonder if the properties are somehow locked. thanks.

Navigation

[0] Message Index