Fabrication CADmep™ > CADmep™ Worksheets & Reports

Elevations on Worksheets

(1/8) > >>

jmerch:
Is there a way yet to get Z elevation of items onto worksheets? Either in 2013 or maybe it was updated in Lok 21 that I don't know about?

Or is there a way to read this in a script so I can put it in another field?

Thanks.

cam-nav:
Item Connector Z Location for reports.

And

item.endlocation(1,"Z") for scripting.
This will only report End 1

item.endlocation("Z")
This will return all end locations.

jmerch:

--- Quote from: cam-nav on Nov 07, 2012, 19:15:57 PM ---Item Connector Z Location for reports.
--- End quote ---

This is not available in Worksheets though, that's what I'm looking for.  If not that, I will use the scripting for now.

cam-nav:
Oh, my bad. That's what I get for not reading close enough.

jmerch:
No prob.  Thanks for the scripting though.  Will see if I can put that to good use.

I thought I talked to some users about the worksheets path and they said they got it working, but I've never seen it.

Navigation

[0] Message Index

[#] Next page