Fabrication CADmep™ > CADmep™ Worksheets & Reports

Elevations on Worksheets

<< < (3/8) > >>

DonWunder:
Put the elevation in a custom field to show in a worksheet.

jmerch:
That's what I'm trying to do now, but need to bottom of hanger elevation.  That's what I'm asking, how do I script that?

DonWunder:
You have everything you need as far as variables for the calculation. You have btm of hanger and top of hanger. Z ele = (BTM + ((top-btm)/2) ) then subtract any od if this was a clevis or roller.

jmerch:
Is there a way to get the outside diameter value in scripting?

DonWunder:
I haven't found a way. We placed the od in all the pipe.

Navigation

[0] Message Index

[#] Next page

[*] Previous page