Fabrication CADmep™ > CADmep™ Worksheets & Reports

Elevations on Worksheets

<< < (2/8) > >>

cam-nav:
I suppose Center of Gravity Z will not work? That is available in Worksheets but I am assuming you are needing end connection Z locations right?

jmerch:
Correct.

VirtualPilot:
Is this what you need?

jmerch:
No, I'm looking for a way to get elevation in worksheets, .wzn file.

jmerch:

--- Quote from: cam-nav on Nov 07, 2012, 19:15:57 PM ---Item Connector Z Location for reports.

And

item.endlocation(1,"Z") for scripting.
This will only report End 1

item.endlocation("Z")
This will return all end locations.
--- End quote ---

How would I get bottom location?  Like in REPORTS you can get Connector Location Z Position Bottom #1.  This is for hangers.  If I do the (1,"Z"), this is center, (2,"Z") is top of rod, and (3,"Z") is still center of hanger.

Navigation

[0] Message Index

[#] Next page

[*] Previous page