...serving the BIM community since 2003
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Forum
Login
Contact
Register
XtraCAD.com
»
Fabrication CADmep™
»
CADmep™ Worksheets & Reports
»
Linear Nest Pipe Reports in 2014 CADmep
« previous
next »
Print
Pages:
1
2
3
[
4
]
Go Down
Author
Topic: Linear Nest Pipe Reports in 2014 CADmep (Read 21387 times)
0 Members and 1 Guest are viewing this topic.
cadmium
Senior Member
Posts: 308
Country:
Gender:
Re: Linear Nest Pipe Reports in 2014 CADmep
«
Reply #45 on:
Jan 16, 2015, 17:57:35 PM »
They are the same pieces of strut, and I don't know why it ends the group without a full length.
see attached, which is page 1.
Would you be willing to share your report?
Logged
BanyasRacing
Active Member
Posts: 4
Country:
Gender:
Re: Linear Nest Pipe Reports in 2014 CADmep
«
Reply #46 on:
Feb 01, 2022, 17:36:59 PM »
can this be used for spiral duct?
the report works great for piping but, when I try to use it for spiral duct I get a message that says "Nothing to print. Please select a different report"
any help is greatly appreciated.
Logged
Print
Pages:
1
2
3
[
4
]
Go Up
« previous
next »
XtraCAD.com
»
Fabrication CADmep™
»
CADmep™ Worksheets & Reports
»
Linear Nest Pipe Reports in 2014 CADmep