Hi Chris.
It's not setting up the splitter tabs that is the problem, see pic for how we would have them on our fully welded specs. The problem is that the number of tabs that are on the splitter is governed by the value shown - see other pic.
A quantity is not the way to go for us because we want the tabs to be at a pitch no greater than a specific value, therefore as splitters vary depending on the bend dimensions we would need to keep adjusting that value - not easy because its a database setting. If there are two or more splitters, or more than one bend in the file then the problem is worse because if we set it to get the right tab number for one splitter, the other/s would have either too many or too few.
I would like to see an "override" for the number of tabs so it can be set to a splitter tab pitch. That way there would be a different number of tabs dependant on the splitter length, which keep it under a "maximum" pitch.