Fabrication CADmep™ > CADmep™ Worksheets & Reports
Report from section datum
Tin_Knockers:
Hey All,
Been a while. I have a report set up to show the hanger elevation as BOP. The problem is that it will not report from the section datum, just AutoCAD 0. Any ideas? See attached.
cadmium:
We are making new (copies) reports for each job, and putting in a calc for the BOP. it is filtered by section number so its hard to screw up, its just blank if you run the wrong report. Not the best method, but it works. Interested to see how others do it.
wmtspaeder:
I transfer the BOH elevation to a custom data field using a script so we can print it on worksheets/stickers. I have a variable in the script to adjust for changes in datum. It works ,but I would like a better solution.
bparrell:
--- Quote from: Tin_Knockers on Sep 04, 2014, 15:21:56 PM ---Hey All,
Been a while. I have a report set up to show the hanger elevation as BOP. The problem is that it will not report from the section datum, just AutoCAD 0. Any ideas? See attached.
--- End quote ---
What are you doing drawing piping? ;D
Tin_Knockers:
Got some plumbers over here that need a bit o help. How ya been Bob?
Navigation
[0] Message Index
[#] Next page
Go to full version