Author Topic: Export Revit piping into CADmep  (Read 447 times)

0 Members and 1 Guest are viewing this topic.

Offline Alina.autocadTopic starter

  • Premier Member
  • *****
  • Posts: 777
  • Country: us
  • Gender: Female
Export Revit piping into CADmep
« on: Dec 12, 2016, 06:54:49 PM »
Good morning guys,

I have Revit 2017 and CADmep 2017.
Is it the same process of export as in 2013 versions? What should I know before start to export?
I read earlier topics and it says I need to install Revit first and then Fabrication
Thanks

Offline madcad

  • Full Member
  • ***
  • Posts: 140
  • Country: gb
  • Gender: Male
Re: Export Revit piping into CADmep
« Reply #1 on: Dec 13, 2016, 09:45:57 AM »
I would investigate the new "Design to Fabrication" function in Revit 2017. It can swap out families to ITM content with good results in a properly setup database.
One failing it that there appears to be no way of telling it too use 28od in place of 25dn for instance.