Author Topic: 2017 CID#866 Invalid Straight Only  (Read 1774 times)

0 Members and 1 Guest are viewing this topic.

Offline TonyDTopic starter

  • Full Member
  • ***
  • Posts: 137
  • Country: us
  • Gender: Male
2017 CID#866 Invalid Straight Only
« on: Jun 16, 2017, 16:29:08 PM »
I have a problem in CAMduct 2017 where CID#866 is no longer being driven by the "Straights Only" in my specification when switching to AUTO length. My length is updated but connectors, seams, and cut type are all referencing "Fittings Only". Has this anything to do with the most recent update version: 2017.2.2.
Tony De Lara
Digital Project Engineering Manager
OmniDuct

Offline Darren Young

  • Premier Member
  • *****
  • Posts: 2132
  • Country: us
  • Gender: Male
    • BIM There Done That.
Re: 2017 CID#866 Invalid Straight Only
« Reply #1 on: Jun 19, 2017, 16:41:03 PM »
Yes, 2017.2.2 is not stable when it comes to straights. There's already a few threads on here about it.

Anyone doing duct fabrication should avoid 2017.2.2.

If you're doing piping, 2017.2.2 finally fixes a lot of the issues w/Spooling and Job info so I'd only recommend upgrading for the piping folks.

Offline TonyDTopic starter

  • Full Member
  • ***
  • Posts: 137
  • Country: us
  • Gender: Male
Re: 2017 CID#866 Invalid Straight Only
« Reply #2 on: Jun 21, 2017, 17:05:57 PM »
Thanks, I will probably have to reinstall 2017 to correct this issue.
Tony De Lara
Digital Project Engineering Manager
OmniDuct