Fabrication CADmep™ > CADmep™ Wish List
how to make BOM using ADDREPORT with fitting Angle and Connecor1 and 2
(1/1)
Kite15:
Hi,
How we can generate a table using ADDREPORT command in Fabrication CADmep(v2015) as (attached snap) fitting angle, insulation, connector#1 and 2 (see the snap)
Thanks... :-[
cadbyken:
Is that your table already? If so, the blanks are correct since those fields would be blank.
You will need a separate table for each type of duct pattern. There are some work arounds to get a combined table for all items. Takes a little bit of work.
Navigation
[0] Message Index
Go to full version