Fabrication in Revit® > Fabrication Parts in Revit®

CID#64 will not allow C3 connector change

(1/1)

cvdemick:
Hello All,

I am trying to use CID#64 in Revit and I cannot change the C3 Connector to anything else than what is defined in my spec. Currently is set to TDC but I need to change it to a 1 inch Flange In for a grille. I can select the right connector but when hit apply it doesn't change the connector. This is Typical for S&D and all other connectors. Other Tap in's work fine in Revit and CID#64 works fine in AutoCAD. Has anyone else seen this issue or know how to resolve it?

Thanks,
Chad--

craigjonnson:
If the connector is connected to another i.e 2 pieces of duct. You cannot change the connector. You will have to disconnect to change the connector type.

Navigation

[0] Message Index

Go to full version