Hi, I have a number of buttons that are stacked and restricted to sizes. Pressfit copper <=50 Brazed <=65 to 150mm for example. Within CADmep these work a treat. I pick the button and the dialogue opens up for all sizes. Yet within ESTmep only the lower sizes are available unless i use the rightclick > takeoff command or remove the restrictions off the larger sized fitting.
Designline still works and selects the required fittings within their restrictions. The attached images show the differences between the 2 programs.
This has been tested in 2017,2019, 2020 & 2021 with the same database.
Is there some setting im not aware of or is this a bug?