Coordination & Design > Services Coordination & Design

Create custom rules for Navisworks.

(1/1)

VDCguy95:
Hello there, I am currently working on a project that is in Navisworks and of course has thousands of clashes. However in using clash detective I am truly only interested in clashes that are partially through an object. For example, if I have a pipe that clears a 7’ run then begins to slope into a existing duct. I tried to create a custom rule alas I cannot seem to isolate this exact case. If anyone could explain if this can be done that would be greatly appreciated.

Navigation

[0] Message Index

Go to full version