Coordination & Design > Services Coordination & Design

Create custom rules for Navisworks.

(1/2) > >>

VDCguy95:
Hello there, I am currently working on a project that is in Navisworks and of course has thousands of clashes. However in using clash detective I am truly only interested in clashes that are partially through an object. For example, if I have a pipe that clears a 7’ run then begins to slope into a existing duct. I tried to create a custom rule alas I cannot seem to isolate this exact case. If anyone could explain if this can be done that would be greatly appreciated.

Alina:
Any suggestions for setting up rules in Navisworks? For insulation, concrete and etc

bparrell:
VDCguy95:
Not necessarly a rule but clearance. Set it to .5" than anything greater than .5 will not clash.

Alina:
this will need a rule. Pick everything in drawing and create a set. Than make a set for just concrete. Go to rules and pick between two sets to ignore and set it to these sets. What happens is the concrete is in both and it ignores it

Alina:
Are you using Fabrication file?

bparrell:
yep . Use all the programs when clashing revit/nwc/nwd/ sprink/ etc

Navigation

[0] Message Index

[#] Next page

Go to full version