Author Topic: Create custom rules for Navisworks.  (Read 770 times)

0 Members and 1 Guest are viewing this topic.

Offline VDCguy95Topic starter

  • Active Member
  • **
  • Posts: 9
  • Country: us
  • Gender: Male
Create custom rules for Navisworks.
« on: Mar 27, 2018, 01:18:51 PM »
Hello there, I am currently working on a project that is in Navisworks and of course has thousands of clashes. However in using clash detective I am truly only interested in clashes that are partially through an object. For example, if I have a pipe that clears a 7’ run then begins to slope into a existing duct. I tried to create a custom rule alas I cannot seem to isolate this exact case. If anyone could explain if this can be done that would be greatly appreciated.