« previous next »
Pages: [1]   Go Down

Author Topic: Cut Plain Distance  (Read 2554 times)

0 Members and 1 Guest are viewing this topic.

Offline ScottieMTopic starter

  • Premier Member
  • *****
  • Posts: 919
  • Country: us
  • Gender: Male
Cut Plain Distance
« on: Apr 02, 2018, 13:45:21 PM »
Hey to all,
I have a couple of recent projects where when I'm walking in the model and turn, it starts slicing the model. It only seems to happen when I'm looking straight ahead or eye level, in certain directions or turning. If I tilt up or tilt down, the model comes back.
I thought it was a origin point issue, both project were placed on a large civil/geographical landscapes. One was almost 100,000 ft from the "origin". Yep that's around 18 miles. To test it, I saved a small part of the model as a different one, and moved it closer, and still had the same thing happening.
Logged
Scott M.
The Dude Abides

Offline nbuch

  • Full Member
  • ***
  • Posts: 61
  • Country: us
  • Gender: Male
Re: Cut Plain Distance
« Reply #1 on: Apr 02, 2018, 17:06:46 PM »
I have had the same issue before, sometimes the whole model disappears when flying through it. Try adjusting the file options as seen in the attached image. This has always cured the issue for me.

Logged

Offline ScottieMTopic starter

  • Premier Member
  • *****
  • Posts: 919
  • Country: us
  • Gender: Male
Re: Cut Plain Distance
« Reply #2 on: Apr 02, 2018, 18:14:26 PM »
Brilliant! That was it, thank you.
Logged
Scott M.
The Dude Abides
Pages: [1]   Go Up
« previous next »