Author Topic: Bullnose type connector  (Read 1345 times)

0 Members and 1 Guest are viewing this topic.

Offline RickDTopic starter

  • Full Member
  • ***
  • Posts: 85
  • Country: us
  • Gender: Male
Bullnose type connector
« on: May 17, 2018, 16:34:57 PM »
Is there a way in CAM to setup a connector that goes down 1" then out away from the fitting 1"? I have looked in the help file but they seem to have decided not to update CAM information. I also did a search here but all the posts are from way back and all graphics attached are not there any more. Any help would be greatly appreciated.

Offline bparrell

  • Premier Member
  • *****
  • Posts: 8819
  • Country: us
  • Gender: Male
Re: Bullnose type connector
« Reply #1 on: May 17, 2018, 16:59:45 PM »
Follow the pic. The graphics will be bad. They never fixed it along with the overall length measurement. Set the draw type to stepdown
The SoCAL (VERY OLDMAN NOW) Kid! LOOKING FORWARD TO MORE  HOLIDAYS BOB  ::) ::)  
WIN 10 O.S
Revit/Fabrication 2022/BDSU 2022
RUDOLPH and SLETTEN
MEP COORDINATOR

Offline RickDTopic starter

  • Full Member
  • ***
  • Posts: 85
  • Country: us
  • Gender: Male
Re: Bullnose type connector
« Reply #2 on: May 17, 2018, 17:38:34 PM »
Thanks! I was hoping for it to draw right but it will work.

Offline bparrell

  • Premier Member
  • *****
  • Posts: 8819
  • Country: us
  • Gender: Male
Re: Bullnose type connector
« Reply #3 on: May 17, 2018, 17:59:06 PM »
It displays right one way but length is off. I choose the other. It's been awhile but I'm sure I described it in older post.
The SoCAL (VERY OLDMAN NOW) Kid! LOOKING FORWARD TO MORE  HOLIDAYS BOB  ::) ::)  
WIN 10 O.S
Revit/Fabrication 2022/BDSU 2022
RUDOLPH and SLETTEN
MEP COORDINATOR

Offline ocdcad

  • Full Member
  • ***
  • Posts: 124
  • Country: us
  • Gender: Male
Re: Bullnose type connector
« Reply #4 on: May 17, 2018, 22:50:47 PM »
We do it slightly different, length and graphic ok in CAD.
End draw type = Standard
Breakpoints:
A & B = 9999
C = 0
D = -1 or 0
E = -1
F = -1
G = 0

« Last Edit: May 17, 2018, 22:54:58 PM by ocdcad »