Bug Reports & Service Pack Updates > General Bug Reports

Hole angle on dampers

(1/3) > >>

hranec:
Is the hole angle on dampers not working in 2019? I cannot get my holes on the right side of my 45 deg tap. Anybody else run into this yet?

hranec:
Can anyone confirm? Is this a bug? The hole rotation does not seem to be working. Or are we missing something?

cadbob:
Post screen shot one of us will try for you and confirm.

This is where it is nice to have small software company (MAP) as opposed to big (Adesk) fixes would be quick

hranec:
I cannot get the rotation on the holes to go to the short end of the duct. It works in 2016. Something either changed or got broke since then.

cadbob:
It's a bug!  :(

Navigation

[0] Message Index

[#] Next page