Fabrication CADmep™ > Designline
Design Line Node X to item picture
(1/1)
Jwisniowski:
When placing nodes specifically for HVAC i would like the item picture to display instead of "X" on the DL. This already is the case for my VCD buttons (which is how i got the idea).
cadragon:
Draw the symbol, create .DXF of it. Attached it to your button using the 'Symbol...' button in Button Properties...
cnash:
When you do as cadragon suggested make sure you play with the size and the "Fixed Size" box, depending on what you have it will affect differently.
Also, orientation of the image is very important.
Jwisniowski:
--- Quote from: cnash on Jul 26, 2018, 13:14:17 PM ---When you do as cadragon suggested make sure you play with the size and the "Fixed Size" box, depending on what you have it will affect differently.
Also, orientation of the image is very important.
--- End quote ---
Does the orientation affect how the node fills?
cnash:
--- Quote from: Jwisniowski on Jul 26, 2018, 13:41:03 PM ---Does the orientation affect how the node fills?
--- End quote ---
No, but it affects how the image is displayed.
Navigation
[0] Message Index
Go to full version