Author Topic: Filling with a Tee with Multiple Offset Branches  (Read 131 times)

0 Members and 1 Guest are viewing this topic.

Offline BonediggerTopic starter

  • Senior Member
  • ****
  • Posts: 443
  • Country: us
  • Gender: Male
    • Hercules Industries
Filling with a Tee with Multiple Offset Branches
« on: Sep 14, 2018, 05:22:49 PM »
Does anyone have any suggestions on how to get Design Line to fill in a tee (cross) with branches that are offset relative to each other (1st picture)? When I fill, it changes the Offset4Way into two RedILTee nodes, but can't fill both because the branches are too close together (2nd Picture). The third picture illustrates what I'm trying to get it to do. If the branches are even, it has no problem filling. It's when the branches are not both centered in the body that it doesn't seem to be able to adjust the branches to match the design.
Chris
Autodesk Fabrication CAMduct 2014 v3.02.502 SP1b, Autodesk Fabrication CAMduct 2018 v3.06.739 (2018.1.0), Autodesk Fabrication ESTmep 2018 v3.06.739 (2018.1.0) Windows 7, 64-Bit