Author Topic: Make MultiSerivce Takeoff Trapeze Tray widths default to even lengths  (Read 333 times)

0 Members and 1 Guest are viewing this topic.

Offline wwesselsTopic starter

  • Full Member
  • ***
  • Posts: 61
  • Country: us
  • Gender: Male
When we do a Multiservice Takeoff with a trapeze hanger is there a way to make the tray width defualt to even numbers of inches ?
So when done on a rack that is 23-17/32" wide it will round up to 24"

Any assistance with this would be much appreciated

Offline cadbyken

  • Premier Member
  • *****
  • Posts: 4851
  • Country: us
  • Gender: Male
Never tried this but you could try to productlist the item by widths and see if it will pick the larger one.  We currently use a script after the fact to round the numbers.
Ken Taylor - (Limbach Eng & Design Services, LEDS)
Have you seen any good youtube videos <--- lately? ;)
AutoCAD MEP V16, Fabrication 2016/17/18...Dell Precision 7710 i7-2.70 GHz/32 GB RAM