Fabrication CADmep™ > CADmep™ Users

Product List Connector Specifications Conflict

<< < (2/2)

cadbyken:
Ok, leaving it catalogued and putting the material in there worked. Surprisingly, it adjusted the gauge according to the specs. Thanks!

cadbyken:
I am close to product listing all of this but I am having an issue with the Easy Bends using CID#108. It isn't connecting regardless of settings. I figure it is because the sizes are opposite of what is normal. If I do swap the dimensions, then the elbow is like a hard bend and not correct.

Navigation

[0] Message Index

[*] Previous page