Fabrication CADmep™ > CADmep™ Worksheets & Reports
Work sheets not allowing me to edit them
(1/1)
lbenjamin58:
i am new to the making of the work sheets/reports. But for the last 2 days i have not been able to figure out why i cant click and drag items to the work sheet. I created a new sheet and everything. It still will not allow placement, nor can i make up a header or footer. Please help.
Lance
VirtualPilot:
Do you have administrator rights to edit the reports?
freshair:
I just had the same problem, took me an hour to figure out I had to right click and use split vertical/horizontal before it would let me add data. It only allows you to add one component per open area, and it seems no data if there are no split lines.
VirtualPilot:
--- Quote from: freshair on Feb 07, 2019, 20:53:49 PM ---I just had the same problem, took me an hour to figure out I had to right click and use split vertical/horizontal before it would let me add data. It only allows you to add one component per open area, and it seems no data if there are no split lines.
--- End quote ---
Yes, and you do have to do a lot of pre-design thinking before you start as the way this space splitting works sometimes yields very undesirable results...
Navigation
[0] Message Index
Go to full version