Author Topic: CAMduct 2018 CID#1206 & 1027 Filter Box- Insulation Cut Size Wrong  (Read 190 times)

0 Members and 1 Guest are viewing this topic.

Offline Dean HuynhTopic starter

  • Active Member
  • **
  • Posts: 49
  • Country: au
  • Gender: Male
Hi all,

We got an issue with the insulation cut size when using CID#1206 and CID#1207 (New filter boxes in CAMduct 2018). Apparently, the cut size of 2 sides of duct are right but the other 2 sides missing the width equal to 4 x "insulation thickness". We did run a check on our insulation specs and connectors/seams, compression ratios but we couldn't find anything related to that 4xinsulation thickness.

Is there anyone who get same issue? Any solution or any idea to get this sorted out?

Look forward to hearing from all and all the contribution will be much appreciated.

Offline Sirius

  • Full Member
  • ***
  • Posts: 73
  • Country: au
  • Gender: Male
Yes, that's been an issue since these patterns were introduced.
It would be nice if some of these known problems were fixed sometime!
We had high hopes that these two CIDs would be very useful and save a lot of editing but since the insulation doesn't come out correct they are useless.

Offline Dean HuynhTopic starter

  • Active Member
  • **
  • Posts: 49
  • Country: au
  • Gender: Male
Thanks for your respone Sirius !

Apparently, we tried upgrade to Camduct 2018 to take advantage of these CID to eliminate time need to spend in Opus but we found out the insulation issue and now it's confirmed by you so look like we still need to use Opus to edit the insulation cut size.

Thanks!