Author Topic: Duct Insulation  (Read 277 times)

0 Members and 1 Guest are viewing this topic.

Offline mdeneringTopic starter

  • Active Member
  • **
  • Posts: 46
  • Country: us
  • Gender: Male
Duct Insulation
« on: Jun 11, 2019, 04:13:59 PM »
We did a job in Revit a few months back. In order to put insulation on we had to create insulation specs. Since then we have been having issues with our Rectangular duct coming in with insulation on it when placing straight ducts and fittings. This is only happening with rectangular ducts. We do not have an insulation spec set for our services. See images. Any help is appreciated.

Offline bknapton

  • Premier Member
  • *****
  • Posts: 945
  • Country: us
  • Gender: Male
    • Mared Mechanical
Re: Duct Insulation
« Reply #1 on: Jun 26, 2019, 08:47:20 PM »
Did you by get this resolved?
Fabrication 2019

Offline mdeneringTopic starter

  • Active Member
  • **
  • Posts: 46
  • Country: us
  • Gender: Male
Re: Duct Insulation
« Reply #2 on: Jun 26, 2019, 09:01:06 PM »
I did figure it out. When placing a piece of duct for the first time or with the attacher arrow off you need to turn the insulation spec off. It will then place duct with the insulation off moving forward.