...serving the BIM community since 2003
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Forum
Login
Contact
Register
XtraCAD.com
»
General
»
General Discussions
»
Insulation doesn't apply to pipe after doing match properties
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Insulation doesn't apply to pipe after doing match properties (Read 688 times)
0 Members and 1 Guest are viewing this topic.
Challenger71
Full Member
Posts: 198
Country:
Gender:
Insulation doesn't apply to pipe after doing match properties
«
on:
Aug 12, 2019, 13:00:25 PM »
I'm trying to apply insulation like I've done before on a piping system and now only some of the pipes and fittings are getting the insulation. What setting is off to where not all the pipes don't have insulation applied to them?
Logged
Challenger71
Full Member
Posts: 198
Country:
Gender:
Re: Insulation doesn't apply to pipe after doing match properties
«
Reply #1 on:
Aug 12, 2019, 13:35:29 PM »
Figured it out but I don't understand what I did differently to set up the service where the "insulation spec" wasn't set.
First time I've run into this.
Logged
Challenger71
Full Member
Posts: 198
Country:
Gender:
Re: Insulation doesn't apply to pipe after doing match properties
«
Reply #2 on:
Aug 21, 2019, 16:21:47 PM »
Ok now I have it. I just need more caffiene. I set up my own Insulation spec according to what service I'm running. Never have done that before but it's easy enough to do.
Logged
Jabbster
Premier Member
Posts: 1062
Country:
Gender:
Re: Insulation doesn't apply to pipe after doing match properties
«
Reply #3 on:
Oct 07, 2019, 17:03:28 PM »
Yes, it seems that insulation specs are much more effective that plain insulation on an item. What I don't understand is why some itm's don't have the option to set an insulation spec
Logged
James
~~~~~
Autodesk Building Design Suite Ultimate 2018 - Fabrication CADmep 2018
Dell Precision 7720
Print
Pages: [
1
]
Go Up
« previous
next »
XtraCAD.com
»
General
»
General Discussions
»
Insulation doesn't apply to pipe after doing match properties