Author Topic: Change spec of service in drawing  (Read 323 times)

0 Members and 1 Guest are viewing this topic.

Offline CurtisKey82Topic starter

  • Active Member
  • **
  • Posts: 1
  • Country: us
  • Gender: Male
Change spec of service in drawing
« on: Jun 19, 2019, 06:57:29 PM »
I have a pipe drawing that has been run in the wrong material. Is there a way to change that pipe spec without going to every piece of pipe in the drawing?

Offline davidratx

  • Premier Member
  • *****
  • Posts: 1253
  • Country: us
  • Gender: Male
Re: Change spec of service in drawing
« Reply #1 on: Jun 19, 2019, 07:10:21 PM »
I have a pipe drawing that has been run in the wrong material. Is there a way to change that pipe spec without going to every piece of pipe in the drawing?
Take it into Revit, use the Type Selector and it will swap them all out w/o touching the fittings.
David Ronson
eVolve Mechanical Product Manager
Windows 10 - Revit - AutoCAD - CADmep - ESTmep - CAMduct

Offline Steadtler

  • Active Member
  • **
  • Posts: 37
  • Country: us
  • Gender: Male
Re: Change spec of service in drawing
« Reply #2 on: Jun 20, 2019, 01:02:57 AM »
Without needing to go into Revit - isolate the piping to change (via layers), use REVDESIGN to generate Design Lines (If you don't have DL's already), Erase 3D items (unfill the DL'ss) and select the service you wish to use for the DL's and then 3D Fill using the new service.