Author Topic: Isolate by Item centerline length  (Read 250 times)

0 Members and 1 Guest are viewing this topic.

Offline jryckmanTopic starter

  • Full Member
  • ***
  • Posts: 201
  • Country: us
  • Gender: Male
Isolate by Item centerline length
« on: Jun 27, 2019, 10:30:20 PM »
I am running into an issue with our flex ducts.  For some reason the Item centerline length (DIM 3) on the flex pattern was locked when we started our current project so that no matter what the length it is locked at 84".  We use this field for reporting.  This will not allow for accurate reports.  I tried unlocking the dimension and running a few other commands.  Is there anyway to update the pattern so that it will report correctly.  At a minimum, I would like to isolate by length to isolate the bad flex runs.  It has been corrected and not all of them are locked now.
Jason Ryckman
Peterson Mechanical
Sheet metal Detailer/BIM Manager
BDSU 2016
Fabrication CADmep 2016

Offline PipeFitter72

  • Full Member
  • ***
  • Posts: 78
  • Country: us
  • Gender: Male
Re: Isolate by Item centerline length
« Reply #1 on: Jun 28, 2019, 03:02:16 PM »
If I am understanding your question, you can use SELECTFILTER (magnifying glass with lightning bolt icon) to filter by centerline length.
Union Piping Designer