Author Topic: Autocad and JPG to Vulcan  (Read 3006 times)

0 Members and 1 Guest are viewing this topic.

Offline asherjohTopic starter

  • Active Member
  • **
  • Posts: 3
  • Gender: Male
Autocad and JPG to Vulcan
« on: Jul 30, 2019, 16:41:45 PM »
My company is very behind the times when it comes keeping up to date with Vulcan. I am trying to take a jpg and cut it on the plasma cutter. The Vulcan version they have does not recognize jpg. I tried importing the jpg into AutoCAD but Vulcan does not seem to recognize any of the AutoCAD formats. Any suggestions? Thank You

Offline bknapton

  • Premier Member
  • *****
  • Posts: 968
  • Country: us
  • Gender: Male
    • Mared Mechanical
Re: Autocad and JPG to Vulcan
« Reply #1 on: Jul 30, 2019, 16:51:01 PM »
Did you try a DXF file by chance?
Fabrication 2019