« previous next »
Pages: [1]   Go Down

Author Topic: Any ideas on best CID (if any) for this odd shaped product...?  (Read 3174 times)

0 Members and 1 Guest are viewing this topic.

Offline wspierTopic starter

  • Active Member
  • **
  • Posts: 8
  • Country: us
  • Gender: Male
Any ideas on best CID (if any) for this odd shaped product...?
« on: Oct 21, 2020, 23:43:19 PM »
Looking to build an Uponor Metal Bend Support - https://www.uponor-usa.com/en/products/metal-bend-supports

It looks similar in geometry to a saddle shield bent 90 deg. along the length. I know I could just use an elbow, and will if no other options.

Thanks
Logged

Offline madcad

  • Senior Member
  • ****
  • Posts: 379
  • Country: gb
  • Gender: Male
Re: Any ideas on best CID (if any) for this odd shaped product...?
« Reply #1 on: Oct 22, 2020, 10:26:40 AM »
I think a bend would be the only way to do that.
Mind you that is not real world is it because it should be one continuous length of pipe through it.
I would just issue the pipe fitter a bag of those to use where required.
Logged

Offline DKH

  • Active Member
  • **
  • Posts: 42
  • Country: us
  • Gender: Male
Re: Any ideas on best CID (if any) for this odd shaped product...?
« Reply #2 on: Oct 22, 2020, 14:51:16 PM »
Pattern 900 can get you close.
Logged

Offline wspierTopic starter

  • Active Member
  • **
  • Posts: 8
  • Country: us
  • Gender: Male
Re: Any ideas on best CID (if any) for this odd shaped product...?
« Reply #3 on: Oct 23, 2020, 04:11:04 AM »
Thanks everyone, and DKH - will give 900 a try tomorrow.
Logged
Pages: [1]   Go Up
« previous next »