Fabrication CADmep™ > Designline

shoe tap on round

(1/1)

bknapton:
Does anyone know of a CID that allows you to product list a shoe tap on round and get it to work with design line?  I've tried CID #871 with no luck yet.

Darren Young:
Why won't this work?  Dumb question...I suppose if you knew that...you'd make it work. ;-)

But seems like it should it matter and this should work. Does it work if not product listed?

bknapton:
It somewhat works.  So far it's only working when I have duct main set to same size as "pipe diameter" on fitting.
Do I need to add "pipe diameter" to product for each size we would use?  Seems like a lot.

cadbyken:

--- Quote from: bknapton on Apr 07, 2021, 13:16:52 PM ---It somewhat works.  So far it's only working when I have duct main set to same size as "pipe diameter" on fitting.
Do I need to add "pipe diameter" to product for each size we would use?  Seems like a lot.

--- End quote ---
Yes, you would need one for each pipe diameter.  Create the productlist in Excel to make the work easier if you like.  Then cut and paste.

bknapton:
I product listed all the options and now it works great.
Thanks for the help!

Navigation

[0] Message Index