Author Topic: CAMduct 2022 damper holes  (Read 917 times)

0 Members and 1 Guest are viewing this topic.

Offline whitney95Topic starter

  • Active Member
  • **
  • Posts: 1
  • Country: us
  • Gender: Female
CAMduct 2022 damper holes
« on: Oct 04, 2021, 23:44:16 PM »
My damper holes on shoe taps are not showing up at all. Not when developing or nesting. If I switch to 2021 CAMduct, damper holes are showing up and getting cut. Can't figure out where this issue is coming from as the databases are an exact copy. Any suggestions?

Offline Darren Young

  • Premier Member
  • *****
  • Posts: 2081
  • Country: us
  • Gender: Male
    • BIM There Done That.
Re: CAMduct 2022 damper holes
« Reply #1 on: Oct 05, 2021, 16:53:26 PM »
I'd stick w/2021 until the 2022.1 updates comes out.

Once 2022.1 update comes out, I'd give it another try.