« previous next »
Pages: [1]   Go Down

Author Topic: Main Facing - Can anyone explain how this works?  (Read 1678 times)

0 Members and 1 Guest are viewing this topic.

Offline craigjonnsonTopic starter

  • Full Member
  • ***
  • Posts: 158
  • Country: au
  • Gender: Male
Main Facing - Can anyone explain how this works?
« on: Oct 08, 2021, 00:21:06 AM »
We are trying to run costs/area for lined and externally lagged ductwork by applying a Main face.
It is experimental, and the results are not adding up.

A 250x250 x 10m (metric) Duct reports 10 sqm. If this duct is broken into TDF frames at 1.4m long, the facing adds 50%
I cannot find any help on any forum regarding facings and their functions. Can someone please explain their use?

Other than hatch patterns :)
Logged

Offline cadbyken

  • Premier Member
  • *****
  • Posts: 5042
  • Country: us
  • Gender: Male
Re: Main Facing - Can anyone explain how this works?
« Reply #1 on: Oct 08, 2021, 01:28:02 AM »
May be  this will help:
http://www.xtracad.com/forum/index.php/topic,12438.0.html

I believe there was something also causing my issues in the database regarding costing.  They were adding in a % for waste from what I remember.  I didn't investigate further since that was beyond my control.
Logged
Ken Taylor - Atlantic Constructors, Inc
Database Manager/ITM content creator but normally working on Mech pipe systems
Have you seen any good youtube videos <--- lately? ;)

Offline Sirius

  • Full Member
  • ***
  • Posts: 112
  • Country: au
  • Gender: Male
Re: Main Facing - Can anyone explain how this works?
« Reply #2 on: Nov 24, 2021, 04:45:46 AM »
Logged
Pages: [1]   Go Up
« previous next »