Author Topic: Reset View Filters  (Read 825 times)

0 Members and 1 Guest are viewing this topic.

Offline patrydufTopic starter

  • Premier Member
  • *****
  • Posts: 1041
  • Country: ca
  • Gender: Male
Reset View Filters
« on: Nov 10, 2021, 20:03:04 PM »
Hello mentors,
I'm looking for the command to add to my shortcuts for "Reset View" in the eVolve filters palette.
It's new in v5.2, but I just can't find it.
Thanks
"Whether you think you can or you can't - YOU'RE RIGHT."
"Que vous croyiez pouvoir ou non - VOUS AVEZ RAISON."

Yvon Dufresne - Novybec
CADmep, CAMduct, Revit, eVolve

Offline bstacks

  • Full Member
  • ***
  • Posts: 167
  • Country: us
  • Gender: Male
Re: Reset View Filters
« Reply #1 on: Nov 10, 2021, 20:17:08 PM »
Hi,
Hot keys for eVolve palettes are tied to the eVolve hotkey listener.
1) Setup a Revit hotkey for the eVolve Element Filter. For example, I use "EV" for eVolve
2 ) Go to the eVolve Element Filter palette and click on Settings to define a command for Reset View, I use "RV"

Go back to your model and type both commands: EV (will cause the eVolve hotkey listener to activate) RV will run the reset view command.

Offline bstacks

  • Full Member
  • ***
  • Posts: 167
  • Country: us
  • Gender: Male
Re: Reset View Filters
« Reply #2 on: Nov 10, 2021, 20:22:47 PM »
Here are some additional screenshots to help in case you need these other steps.

Offline patrydufTopic starter

  • Premier Member
  • *****
  • Posts: 1041
  • Country: ca
  • Gender: Male
Re: Reset View Filters
« Reply #3 on: Nov 10, 2021, 21:22:18 PM »
Ok, Thanks Brett.
I was trying without the listener...
"Whether you think you can or you can't - YOU'RE RIGHT."
"Que vous croyiez pouvoir ou non - VOUS AVEZ RAISON."

Yvon Dufresne - Novybec
CADmep, CAMduct, Revit, eVolve