Fabrication in Revit® > Dynamo for Autodesk┬« Revit

Help accessing hanger ancillary info in Revit

<< < (2/4) > >>

bitterfitter:
Thank you.  I really hated to ask for your help again after you took the time to post the node in the first place.

acad2015:

--- Quote from: bitterfitter on Feb 01, 2022, 15:02:07 PM ---Thank you.  I really hated to ask for your help again after you took the time to post the node in the first place.

--- End quote ---

Don't worry about that. If I have time to help, I will.

bitterfitter:
acad2015 - I think I broke it already..  ;D

I seem to be getting an error in line 35 - I may take a break and come back to this.  Starting to see double already LOL

acad2015:
Haha. Ok. I'll try and find time to make a working version.

bitterfitter:
Here is a little info that might help.  I ran the node the first time and it generated the list of AncillaryIds as expected.  When I tried running it again, I started getting the error in line 35.  I even tried running the original node you posted and now I get an error at line 35 on that one also.  I am starting to think I may have broken something good.. :(

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version