Fabrication in Revit® > eVolve Mechanical Users

Satisfaction with eVolve

<< < (3/3)

Darren Young:

--- Quote from: Tstright on Jun 28, 2022, 19:14:05 PM ---We switched to BIMrx after a few months....

--- End quote ---

They're on our list to test (among others) including considering having the tools we need developed ourselves.

dbanker:
This plug in was supposed to fill in the gaps that Revit was missing and so far it's not filling in all the gaps. It's ok but still needs lots of work. One issue that blows my mind is not having the Job Info available to edit so we can properly use the fab reports fill in the header. There are other big gaps still. And yes i have used their suggestion portal but to no avail...

Navigation

[0] Message Index

[*] Previous page

Go to full version