Author Topic: Issue binding design model to project  (Read 1467 times)

0 Members and 1 Guest are viewing this topic.

Offline Tye AustinTopic starter

  • Full Member
  • ***
  • Posts: 72
  • Country: us
  • Gender: Male
Issue binding design model to project
« on: May 20, 2022, 18:52:19 PM »
I am trying to bind the design model to the project but getting the error below.  No details...   Anyone else had this issue?  I have done it with no issues before.
Plumber / Pipefitter / Lead Detailer
Local 447

Make sure present you always takes care of future you so future present you doesn't think past you is a total jerk

Online sephirothnk

  • Active Member
  • **
  • Posts: 7
  • Country: us
  • Gender: Male
Re: Issue binding design model to project
« Reply #1 on: Mar 29, 2024, 12:53:17 PM »
Are you trying to bind with Levels and Grids or without? I think I had this issue before and it was a Levels issue, there was a very slight difference in one of the Models levels (either mine or the one I was trying to bind) that I couldnt see until I changed the units to decimal and had the decimal units show like .000000000001 places. Then I reset the level that was off to the right distance.