Author Topic: Mastering Design to Fabrication in Revit?  (Read 1383 times)

0 Members and 1 Guest are viewing this topic.

Offline tzframptonTopic starter

  • Active Member
  • **
  • Posts: 33
  • Country: us
  • Gender: Male
Mastering Design to Fabrication in Revit?
« on: Jun 11, 2022, 21:38:36 PM »
Has anybody really "mastered" the Design to Fab in Revit? It works fairly well for us on pipe and duct, but we get hung up pretty good on sloped pipe such as storm or any DWV system. I'm not sure if it's my Design Line setup, or my content just isn't really that good or what. Thought I'd see if anybody out there has had any luck and if you found a pattern on what to do and what not to do. Thanks!