Author Topic: Fill Between 2 Ends uses Designline, or not?  (Read 495 times)

0 Members and 1 Guest are viewing this topic.

Offline patrydufTopic starter

  • Premier Member
  • *****
  • Posts: 1044
  • Country: ca
  • Gender: Male
Fill Between 2 Ends uses Designline, or not?
« on: Aug 26, 2022, 16:42:48 PM »
 I'm trying to figure out what nodes the F2E command is using to fill the gap...
I know I can display the designline and display the nodes while in the designline module, but how can I know what node CADmep is looking for with the F2E command?
 Seems like it gathers its instructions elsewhere.... but where?
Thanks
"Whether you think you can or you can't - YOU'RE RIGHT."
"Que vous croyiez pouvoir ou non - VOUS AVEZ RAISON."

Yvon Dufresne - Novybec
CADmep, CAMduct, Revit, eVolve

Offline bobcat09

  • Senior Member
  • ****
  • Posts: 471
  • Country: us
  • Gender: Male
Re: Fill Between 2 Ends uses Designline, or not?
« Reply #1 on: Aug 26, 2022, 21:56:41 PM »
F2E should give you this dialog box. Yes will use Design Line, No will use the older method. The older method does not use DL. If you have selected Don't Show This Message Again, it will default to the Yes (DL) method. As far as what node it selects, I would assume it selecting the node from the 2 items you select.
Lyle Janda
TDIndustries
Windows 10- AutoCAD - CADmep - ESTmep - CAMduct - Revit - Navisworks