Fabrication CADmep™ > Designline

Piping - Mixing end connectors VIC and Beveled

(1/1)

dopefish:
Hello Xtracad! I am making some nodes that will fill in a few components when taking a tap off a main. I am attempting to cut in a fishmouth x groove and a grooved coupling. I can get them to fill but the problem I have is the next piece has a beveled end connector and not a groove. Has anyone ran into this before and solved it?

cadbyken:
next piece, as in the pipe attached to the grooved coupling is beveled?  If so, try unlocking the connector on the pipe and it should match up to what it is connecting to.

dopefish:
I have tried that but the designline seems to just add the pipe and call it a day. Good suggestion though.

Navigation

[0] Message Index

Go to full version