« previous next »
Pages: [1]   Go Down

Author Topic: Piping - Mixing end connectors VIC and Beveled  (Read 385 times)

0 Members and 2 Guests are viewing this topic.

Offline dopefishTopic starter

  • Senior Member
  • ****
  • Posts: 286
  • Country: us
  • Gender: Male
Piping - Mixing end connectors VIC and Beveled
« on: Jun 24, 2022, 21:09:41 PM »
Hello Xtracad! I am making some nodes that will fill in a few components when taking a tap off a main. I am attempting to cut in a fishmouth x groove and a grooved coupling. I can get them to fill but the problem I have is the next piece has a beveled end connector and not a groove. Has anyone ran into this before and solved it?
Logged
"And the wood header is still 4  3/4" on top of the top of the double top plate." . . . Random VDC Coodinator

I love coordination

Offline cadbyken

  • Premier Member
  • *****
  • Posts: 5064
  • Country: us
  • Gender: Male
Re: Piping - Mixing end connectors VIC and Beveled
« Reply #1 on: Jun 25, 2022, 03:19:24 AM »
next piece, as in the pipe attached to the grooved coupling is beveled?  If so, try unlocking the connector on the pipe and it should match up to what it is connecting to.
Logged
Ken Taylor - Atlantic Constructors, Inc
Database Manager/ITM content creator but normally working on Mech pipe systems
Have you seen any good youtube videos <--- lately? ;)

Offline dopefishTopic starter

  • Senior Member
  • ****
  • Posts: 286
  • Country: us
  • Gender: Male
Re: Piping - Mixing end connectors VIC and Beveled
« Reply #2 on: Jun 26, 2022, 03:37:42 AM »
I have tried that but the designline seems to just add the pipe and call it a day. Good suggestion though.
Logged
"And the wood header is still 4  3/4" on top of the top of the double top plate." . . . Random VDC Coodinator

I love coordination
Pages: [1]   Go Up
« previous next »