Fabrication in Revit® > eVolve Mechanical Users

Disconnects with P-traps on gravity systems

(1/1)

Tye Austin:
I've been having an issue with P-traps wanting to disconnect while I'm doing other work.  I will maybe cut in a tee or wye somewhere and I get the disconnect dialog box and then multiple P-traps will disconnect and the pipe that was previously connected will stretch past the end of the P-trap by maybe 10" or so...  It doesn't seem to matter how I put in the P-traps.  Anyone else having this issue?

Navigation

[0] Message Index

Go to full version