Author Topic: Male notch CID#2  (Read 1355 times)

0 Members and 1 Guest are viewing this topic.

Offline dexyweescotTopic starter

  • Senior Member
  • ****
  • Posts: 328
  • Country: gb
  • Gender: Male
Male notch CID#2
« on: Aug 15, 2022, 09:21:56 AM »
I have been requested by our workshop if I can open up the notch for the internal fold only on transitions to save them snipping out all the time.

I know you can change the angle but then it changes the angle on both the internal and external & also the female seam notches. The external fold point is fine at 40o but too small on the internal. If I open the angle up then your left with very little on the internal & the female seam is miles too big.

Is there any way to change the angle on each one? does anyone know a work around?

Offline zhenja83

  • Active Member
  • **
  • Posts: 32
  • Country: 00
  • Gender: Male
Re: Male notch CID#2
« Reply #1 on: Aug 18, 2022, 13:27:05 PM »
Got the same problem and it is still no solution :( The only way is edit it manually in opus.