Author Topic: eVolve Point Loads  (Read 742 times)

0 Members and 1 Guest are viewing this topic.

Offline dbankerTopic starter

  • Full Member
  • ***
  • Posts: 72
  • Country: us
  • Gender: Male
eVolve Point Loads
« on: Sep 29, 2022, 13:57:30 PM »
Does anyone know how the eVolve point load command reports the point load? If i have a hanger that has 2, 3 points/rods etc, does it report for the entire hanger or for each point on that hanger?
Doug Banker
BIM/IT Manager
(CADmep, ESTmep, CAMduct, Revit, Navisworks, BIM 360)

Offline MEPin3D

  • Active Member
  • **
  • Posts: 2
  • Country: us
  • Gender: Male
Re: eVolve Point Loads
« Reply #1 on: Sep 30, 2022, 18:28:07 PM »
I tinkered with the new feature this week. I was able to get a point load for each hanger rod on a trapeze hanger. That hanger only had 2 points. Did not try on hangers with multiple rods.