Author Topic: Button Mapping for 2" Half Couplings  (Read 366 times)

0 Members and 1 Guest are viewing this topic.

Offline mjohnson7Topic starter

  • Active Member
  • **
  • Posts: 16
  • Country: us
  • Gender: Male
Button Mapping for 2" Half Couplings
« on: Jan 20, 2023, 16:44:39 PM »

  I have my button mapping working to a point now where everything executes properly but one scenario. I have been tweaking it here and there to try and execute a 2" half coupling at the 2-1/2" steel to 2" copper break point. We BUGO our welds here, so the shop foreman prefers these to beveled x threaded nipples. We have had issues with the threads after transportation and material handling, so I can see his solution as workable. Does anyone know if there is a way to map out just that break point without jeopardizing any of the other reducing outlets?

Otherwise adding it in on the slight occasions that I need to use them is not a problem.

Offline craigjonnson

  • Full Member
  • ***
  • Posts: 190
  • Country: au
  • Gender: Male
Re: Button Mapping for 2" Half Couplings
« Reply #1 on: Jan 24, 2023, 00:44:30 AM »
I apply size restrictions on the itms and everything else is controlled with connectors and button maps.