« previous next »
Pages: [1]   Go Down

Author Topic: Revit 2021 navis export doesn't include Fabrication Service Abbreviation  (Read 297 times)

0 Members and 1 Guest are viewing this topic.

Offline epond83Topic starter

  • Active Member
  • **
  • Posts: 16
  • Country: us
  • Gender: Male
Revit 2021 navis export doesn't include Fabrication Service Abbreviation
« on: Feb 01, 2023, 17:26:24 PM »
In revit 2020 when we export to navis 'Fabrication Service Abbreviation' shows up in the element properties which we use in our appearance profiler.
Now that we are working in revit 2021 this parameter is not exporting. Before I go rework our profiler does anyone know how to get this working.
I hope Autodesk didn't remove these ability...

Logged

Offline epond83Topic starter

  • Active Member
  • **
  • Posts: 16
  • Country: us
  • Gender: Male
Re: Revit 2021 navis export doesn't include Fabrication Service Abbreviation
« Reply #1 on: Feb 01, 2023, 17:40:21 PM »
I found under the 'Elements Properties' tab there is 'ServiceAbbreviation' property so I'm going to use that instead.
Logged

Offline PHB-Russell

  • Active Member
  • **
  • Posts: 27
  • Country: us
  • Gender: Male
Re: Revit 2021 navis export doesn't include Fabrication Service Abbreviation
« Reply #2 on: Feb 16, 2023, 11:37:11 AM »
I too came across this issue, Autodesk likes to change little things around. Just like inserting RFA's, some old tables use pounds when Autodesk now uses pounds_force and there are quite a few more. The most annoying one is pre-2021 Revit you can select an assembly to use in a fabrication report, but 2021 and newer you can not.
Logged
Pages: [1]   Go Up
« previous next »