Author Topic: edit pattern  (Read 755 times)

0 Members and 1 Guest are viewing this topic.

Offline joseriosTopic starter

  • Full Member
  • ***
  • Posts: 67
  • Country: es
  • Gender: Male
edit pattern
« on: Mar 13, 2023, 11:38:26 AM »
HI all,
I am editing one part to fix connectors. after saving  I go to the connectors to add the item to a job and they are not saved as I did before.
Can you help?

Offline Axl

  • Full Member
  • ***
  • Posts: 169
  • Country: us
  • Gender: Male
Re: edit pattern
« Reply #1 on: Mar 13, 2023, 12:14:14 PM »
One cause could be the name,
Try changing the name of the connectors (at least slightly) , I've seen when two connectors has almost the same name or if even you try to save it with the same name, it won't save, is kind of that the original connector has precedence.
CADmep DB Manager
Content Manager
Scripting

Offline joseriosTopic starter

  • Full Member
  • ***
  • Posts: 67
  • Country: es
  • Gender: Male
Re: edit pattern
« Reply #2 on: Mar 14, 2023, 12:52:28 PM »
Gonna try

Offline Darren Young

  • Premier Member
  • *****
  • Posts: 2081
  • Country: us
  • Gender: Male
    • BIM There Done That.
Re: edit pattern
« Reply #3 on: Mar 14, 2023, 21:37:13 PM »
Are the connectors or ITM using Versioning or Owner information?

Are you editing the part or the connector (as in change the connector details)?

If you're changing the connector ON the part (as in to another connector), then the Specification is likely driving the connector.